Add a message to the login form

This option is part of the modern Login & registration module.

Enter safe HTML in Login form message. WordPress informational notices take priority, and unsafe markup is removed on output.

Configure the option

1. Open Settings → POM Tweaks → White labelling → Login & registration.
2. Enable the Login & registration module if needed.
3. Select Show a login form message and configure any associated values.
4. Save, reopen the tab, and verify the intended behavior in a private browser window while keeping an administrator session open.

Disable the option

Clear Show a login form message and save to stop this behavior. Disabling the whole module stops all its login and registration behaviors. Existing sessions, accounts and delivered emails are not reversed.

For prerequisites, all controls, verification steps and troubleshooting, read Configure login and registration.